|
Browse By Category
Browse By Manufacturer
Browse By Department
Help & Info
TIA568 Wiring Standards
How to decide which wiring pattern to use:
1. Does the job specification call out a wiring pattern?
2. Does the customer/end user have a preference for T568A or T568B?
3. Have patch panels already been purchased for the job? If so, they will probably be either T568A or T568B. The jacks should be wired to the same pattern as the panels.
4. Are you adding on to an existing wiring plant? If so, your new wiring should match the existing wiring.
If none of the factors above apply, either T568A or T568B may be used. It is important to ensure that the workstation connectors and the patch panels are wired to the same pattern. T568B is commonly used in commercial installations, while T568A is prevalent in residential installations.
Click Here for a Full-Color Acrobat pdf file ( 697k ) - Right click to save it to disk.
For a more complete selection of products (no online ordering available at that site), visit the original Lashen Electronics website located at http://www.lashen.com.
|
|
|
The LCD-CM2 adapter allows the LCD-1C to accommodate two 10quot; to 23quot; flat panels.
- adapts an LCD-1C to accommodate two LCD monitors
- holds most 10" – 23" LCD monitors
- accommodates monitors with 75 or 100mm VESA standards
- has adjustable -5° to +30° tilt and rotates 240° at monitor
- LCD-CM2 and LCD-1C combined load capacity 50 lbs
Price: $39.56
|
|
