Language:  
Currency:
VAT Mode:
Search
 go
Browse By Department


Help & Info

TIA568 Wiring Standards

How to decide which wiring pattern to use:

1. Does the job specification call out a wiring pattern?
2. Does the customer/end user have a preference for T568A or T568B?
3. Have patch panels already been purchased for the job? If so, they will probably be either T568A or T568B. The jacks should be wired to the same pattern as the panels.
4. Are you adding on to an existing wiring plant? If so, your new wiring should match the existing wiring.

If none of the factors above apply, either T568A or T568B may be used. It is important to ensure that the workstation connectors and the patch panels are wired to the same pattern. T568B is commonly used in commercial installations, while T568A is prevalent in residential installations.

Click Here for a Full-Color Acrobat pdf file ( 697k ) - Right click to save it to disk.


For a more complete selection of products (no online ordering available at that site), visit the original Lashen Electronics website located at http://www.lashen.com.

Now In: LevitonLeviton Structured Media → Leviton 48210-VA Video Amplifier

Leviton Video Amplifier


Leviton Video Amplifier

Leviton 48210-VA Video Amplifier

E-mail this product to a friend E-mail this product to a friend


Previous  Up  Next" 

48210-VA - Run off-air TV and other video service signals through this Video Amplifier Module and boost video signal strength to performance levels of up to 25 dB. Features a variable attenuator to attain a precise amount of signal amplification and assure the best, clearest signal possible, and an FM trap to eliminate unwanted FM interference.

NOTE: Not for Cable TV or Satellite distribution

FEATURES

  • Variable attenuator enables precise amplification for the clearest signal possible.
  • Run off-air TV or other video signals through the Video Amplifier before splitting and distributing throughout the home or office.
  • Boost signal strength by up to 25 dB.

Specifications

Video Amplifier Module

Frequency Range MHz: VHF: 50-450 , UHF: 470-860
Gain (dB) 40 MHz: 23.8, 54 Mhz:27, 210Mhz:29, 860 Mhz:27
Noise Figure: VHF:6, UHF:6.5
Response Flatness: VHF:2, UHF:3
Gain Control dB: VHF: -10dB, UHF: -10dB
FM Trap dB: 20
Impedance: 75 Ohm
Connector Type: ‘F’
Power Source: 12-15 VDC 500 mA
Dimensions: 6.58" x 3.67" x 4.4"

Price: $38.51 


Quantity:  




QuickPort® Snap-In Modules with 3.5mm Stereo Jack, Female to Screw Terminal
Leviton 40839 Series QuickPort® Snap-In Modules with 3.5mm Stereo Jack, Female to Screw Terminal
Leviton 41080 Series QuickPort Single-Gang Wallplate
Leviton 41080 Series QuickPort Single-Gang Wallplate
QuickPort® Binding Post Snap-In Modules - Black Stripe
Leviton 40833-B Series QuickPort® Binding Post Snap-In Modules
Blank QuickPort® Module
Leviton 40859 Series Blank QuickPort® Module



Product Rating: (0.00)   # of Ratings: 0   (Only registered customers can rate)

There are no comments for this product.