Bogen CMP1R Compressor Limiter Module

TIA568 Wiring Standards

How to decide which wiring pattern to use:

1. Does the job specification call out a wiring pattern?
2. Does the customer/end user have a preference for T568A or T568B?
3. Have patch panels already been purchased for the job? If so, they will probably be either T568A or T568B. The jacks should be wired to the same pattern as the panels.
4. Are you adding on to an existing wiring plant? If so, your new wiring should match the existing wiring.

If none of the factors above apply, either T568A or T568B may be used. It is important to ensure that the workstation connectors and the patch panels are wired to the same pattern. T568B is commonly used in commercial installations, while T568A is prevalent in residential installations.

Click Here for a Full-Color Acrobat pdf file ( 697k ) - Right click to save it to disk.

For a more complete selection of products (no online ordering available at that site), visit the original Lashen Electronics website located at http://www.lashen.com.

Newsletter


Email Address

Bogen CMP1R Compressor Limiter Module

Output Modules Data Sheet

The CMP1R module is a compressor/limiter module that can be used as a compressor to minimize the differences in level of all of the inputs on the mix bus, or can be used as a limiter to keep overall output at a desired level.

Compressor ratio control
Threshold control
Make-up gain control
Bypass switch
Unbalanced input with low priority
Gradual fade back from mute for unbalanced input
RCA connectors

NOTE: These output modules only work with the Power Vector Series

Price: $104.17

Quantity:


Bogen ANS1R Ambient Noise Sensor Module	Bogen NR100 Night Ringer Module	Bogen OCS1 Orbit Ceiling Speaker	Bogen PM3180 ProMatrix Digitally Matrixed 3-Channel Auto-Switching Amplifier

Product Rating:

(0.00) # of Ratings: 0 (Only registered customers can rate)

There are no comments for this product.