Output Modules for Bogen Amps available from Lashen Electronics: ANS1R - Ambient Noise Sensor, ANS500M Sensor Microphone, CMP1R - Compressor/Limiter, PEQ1R - Parametric Equalizer, RIO1S - Relay Input/Output, MA3

TIA568 Wiring Standards

How to decide which wiring pattern to use:

1. Does the job specification call out a wiring pattern?
2. Does the customer/end user have a preference for T568A or T568B?
3. Have patch panels already been purchased for the job? If so, they will probably be either T568A or T568B. The jacks should be wired to the same pattern as the panels.
4. Are you adding on to an existing wiring plant? If so, your new wiring should match the existing wiring.

If none of the factors above apply, either T568A or T568B may be used. It is important to ensure that the workstation connectors and the patch panels are wired to the same pattern. T568B is commonly used in commercial installations, while T568A is prevalent in residential installations.

Click Here for a Full-Color Acrobat pdf file ( 697k ) - Right click to save it to disk.

For a more complete selection of products (no online ordering available at that site), visit the original Lashen Electronics website located at http://www.lashen.com.

Newsletter


Email Address

Bogen RIO1S Relay Input/Output Module

Data Sheets

Bogen's RIO1S is a multi-functional module with a priority-controlled relay contact, transformer-balanced input, transformer-balanced output, and an RJ11 output for direct connection to the override input of a zone paging system.

The RIO1S provides a convenient way to integrate a Power Vector amplifier with a PCM zone paging system, allowing full use of the Power Vector's priority structure in zone paging applications for more sophisticated paging capabilities.

Transformer-isolated, balanced line-level input
600-ohm or 10k-ohm (jumper selectable) input impedance
Transformer-isolated, balanced line-level output
8-ohm, 0.75W output
Input and output level controls
Relay responds to jumper selectable priority level
N.O. or N.C. jumper-selectable relay contact
External control of priority muting buses
Input can be muted from higher priority modules, with signal fade back
Output (normally gate) can be synched with priority relay operation
Output gating can be defeated via jumper
RJ11 connection with line output and dedicated N.O. relay contact (allows easy connection to O/R port of Bogen telephone paging interfaces)
Screw terminals

NOTE: These output modules only work with the Power Vector Series

Price: $71.15

Quantity:


Bogen PEQ1R Parametric Equalizer Module	Bogen CMP1R Compressor Limiter Module	Bogen ANS1R Ambient Noise Sensor Module	Bogen NR100 Night Ringer Module

Product Rating:

(0.00) # of Ratings: 0 (Only registered customers can rate)

There are no comments for this product.